To show them in your local time you can join the forum, and then set the 'time correction' field in your profile to the number of hours difference between your location and UTC time. The dates and times for posts above are shown in Universal Co-ordinated Time (UTC). If (digitalRead (BRAKE_SWITCH_PIN) = LOW)

However if the RH indicator is flashing and you press the LH switch it changes to the LH indicator. Once either light is on pressing either switch cancels it. If you press the 'brake' switch the brake light comes on only for as long as the switch is pressed. If you press the LH switch the LH light starts blinking, ditto for the RH switch and the RH light. Motorcycle turn indicator with brake light If (millis () - lastBlink >= BLINK_INTERVAL) RHswitch.begin (RH_SWITCH_PIN, handleRHPress) LHswitch.begin (LH_SWITCH_PIN, handleLHPress) If (state = RH_DOWN) // if down, switch to down-and-released mode Void handleRHPress (const byte newState, const unsigned long interval, const byte whichPin) The switch manager has used the chip of the Ethernet switch device. If (state = LH_DOWN) // if down, switch to down-and-released mode The Industrial Ethernet and Arduino Board based Solution for controlling systems. otherwise switch is now down, but not yet released if already on or warning signal, turn all off if other switch down, switch to warning mode Void handleLHPress (const byte newState, const unsigned long interval, const byte whichPin) Nick Gammon Australia (22,751 posts) bio Forum AdministratorД¬onst unsigned long BLINK_INTERVAL = 500 // ms This lets you share the callback function between multiple switches. Modified 12 th February 2015 to pass the pin number to the callback function. Unzip and place the folder SwitchManager inside your 'libraries' folder. This turns on one LED if the switch is pressed for a brief time, and the other LED if it is pressed for a longer time. Void handleSwitchPress (const byte newState, const unsigned long interval, const byte whichPin) whichPin will be which pin caused this change (so you can share the function amongst multiple switches) interval will be how many ms between the opposite state and this one newState will be LOW or HIGH (the is the state the switch is now in)

Switchmanager arduino library